-
Setting up shop
A little later today I'll begin clearing out the garage. Originally I was planning to turn the double garage into a rec room and the single into my shop; now the double will become the car shop and the single a workshop. I hauled the DJ from Virginia down here last week, finally picking up the carb and the manifolds my brother repaired. Once I clear out the garage the Willys will go up on stands and work will begin. Ordered the manifold gaskets Thursday but I'm still awaiting confirmation the order went through. Surprisingly the seven year old battery took a charge and passed a load test, so my first task will be slapping the manifolds and carb back on and seeing if she will still run. The spare F-head motor will go on stand (when I get one) and I'll see how good or bad the condition of it is. That will probably be sold intact or parted out, or swapped for another L-head. I'll be checking out the transmission too but will probably keep it as a spare. From the limited info I have found on the DJ3A it came stock with the L-134 engine, T-96 transmission and Dana 27 rear axle. The spare parts likely came from a CJ, so I expect the spare tranny is a T-90.
Anyway, my first project is to get her running again. Depending on how that goes, I'll start working on the body. The steering column shifter is a pain and binds up shifting to second and third, so I will either replace the bushings in the linkage or try to find if a T-90 floor shifter will work in my transmission. The floorboard and transmission have plates for a floor mounted shifter. Money and time permitting, I think this will be a nice little project vehicle. As is, the thing is just plain fun to drive around. But, with a little bit of imagination, it could be a great project. Swap in a larger motor and make it a sleeper, or swap in a CJ drivetrain and make it the 4WD Jeeps were designed to be. Reading an article about another DJ showed me how a little knowledge and ingenuity can turn a Dispatcher into an off-road beast. Similarly, my neighbor was a hot-rodder in the Eighties and has given me some of his own ideas. Honestly, I don't need speed or off-road prowess right now, just a little something to occupy my weekends.
-
I like seeing them turned into drag cars and offroad vehicles, but to each his own. What year is the willy's?
-
It's a 1960. Got the manifolds and carb back on yesterday but there is only a small spark. Next are plug wires and, if needed, a coil. Go figure, the carb was put together wrong had to take apart the old one and the rebuilt one to figure out the problem. The tops were different anyway, so I replace the old float and used the top from the old carb.
Depending on how this goes, I really want to get a 4WD flatfender. Seems like CJ3As are not hard to find, and they use the same motor and body as my DJ.
-
The neighbor just gave me a like-new fluorescent fixture with electronic ballast for the workshop, he has two brand new fixtures for the main shop. Also, a bunch of telephone poles, one of which will go towards the workbench. It's nice having an electrician as a neighbor. Waiting to get the money for plug wires and, if needed, a coil. Once the engine is running, it goes up on jackstands and we'll see how the brakes and bearings look. The fenders were to come off this weekend, but I'm waiting for now. Need to remember to charge the camera batteries so I can get some pics prior to disassembly.
-
Setting up shop
Hi
We will shortly be moving premises and I am looking at setting up a VOIP system
Has anyone got any experiences with this or information they could pass along?
Angus
-
You're posting in the wrong place. If you can't figure out how a forum works then maybe you shouldn't be setting up a VOIP system. lol just my 2 cents.